Electronics Forum | Fri Apr 22 08:00:50 EDT 2005 | bobpan
we had schematics and a disk inside the rear cover assy in ours. You may want to check under that cover.
Electronics Forum | Fri Apr 15 15:04:02 EDT 2005 | lyrtech
Hi, Sometimes we have the following error: " TABLE BASE NOT GOOD ". In the manual, it says that we have to check the cylinder and other parts around the table. This is not very specific. Can anyone helps us with some hints? Thank you
Electronics Forum | Tue May 03 07:50:18 EDT 2005 | scotceltic
Rob, I have soft copies of the GS1 Manuals if that would help. Just curious what your issues are, I may be able to offer help.
Electronics Forum | Mon May 02 08:09:10 EDT 2005 | kodex
We are looking for full set of operation/maintenance manuals for CR Technologies, CRX-2000 x-ray inspection system. Thank you, Gary Korkala
Electronics Forum | Thu Jun 16 08:41:45 EDT 2005 | ghenning
Hi Fred, Were you able to develop enough confidence with the AOI to eliminate manual visual inspections and save money/time? How did you manage this and still get good solder joint quality? Thanks, George
Electronics Forum | Thu May 26 05:46:14 EDT 2005 | ajaydoshi
What is the exact error message? or error code? Machine stop ramdonly. No error code if try to reset error it show T , turn power off. then turn off power . start again. set cam angle manually to origion & start. thanks ajay
Electronics Forum | Sat May 28 02:52:17 EDT 2005 | ajaydoshi
We have AOI photondynamic 7750. Problem 1. it hang very often. 2. During starting of day x axix does not move. we need to move manually & then start otherwise it will not move by machine motor. ajay
Electronics Forum | Sat Jun 03 20:27:39 EDT 2006 | eeltec
Dear MrMaint, I have a COMET machine and I need to calibrate the X axes of table B that it is of by aprox 0.2%. Please help, the manual do not tell how to do this. Best regards, Greg
Electronics Forum | Mon Jun 06 11:56:45 EDT 2005 | ratsalad
Thanks for the leads. They both said they might have one and they are checking into it. I was right the first time! All three cameras are the same. It was the Panasonic help desk that told me they were not. Checking in the manual shows all three
Electronics Forum | Tue Jun 07 22:01:56 EDT 2005 | KEN
run shutdown.rcp after 45 minutes computer will load shutoff.rcp. Is this file not being loaded? If yes, then you have not defined the shutoff event in the scheduler. Poke around in the scheduler. Or check out the software manual. someone probab