Electronics Forum | Tue Mar 12 09:56:50 EDT 2013 | emeto
Hi, I don't know what you mean by really odd parts. Are they SMT parts that have a flat surface to pick them up? If so, probably several machines can do it. I know for sure Siemens can place almost anything. THey will help you with any type of nozzl
Electronics Forum | Sun Mar 24 17:28:20 EDT 2013 | vikkaraja
Thanks for all the help you are giving me but I just can't put my finger on this annoying problem. I checked and recheck all sensors without much sucess against the I/O. Something I am not understand is these two followning conditions--- first one I
Electronics Forum | Tue Apr 09 14:54:22 EDT 2013 | christian01976
Hello! I dont know where you are from but here in Germany Assembleon stopped selling Yamaha machines. Yamaha now sells their machines on their own. The things I know: Yamaha YS24 is equal to Assembloen MC24 Yamaha YS24x equal to MC24x YS12 is MC12
Electronics Forum | Fri Apr 05 18:22:18 EDT 2013 | Adam
We have two ZipaTec 460s Selective Solder Machines, one for Lead and one for Lead-Free. This morning we noticed the solder pot was covered in solder balls, and after asking the operator what they had run, the answer was "Nothing." The operator had al
Electronics Forum | Mon Apr 29 12:32:18 EDT 2013 | stephendo
Do you watch when it is doing the wave height test? Watch it and see if it goes up to the same spot on the test probe each time. If the test probe is dirty sometimes the solder has to go up higher on it before it gets detected. You might actually be
Electronics Forum | Wed May 01 15:27:22 EDT 2013 | lheiss
Hi All, I've been using a IVc for many years. I'm to the point where I have Mod Code 8 = 15, MC9 = 500, and all Extents PU delays set to 40ish. These settings work pretty well but I would like to get them closer to factory defaults to save the los
Electronics Forum | Mon May 06 19:21:39 EDT 2013 | amelby
We had that problem on our M12. There were a few > components that had gotten dropped into the > camera area as the hydra head past over it. Our > MY12 has a knob towards the front of the machine > in direct line with the camera. Pulling this
Electronics Forum | Fri May 31 18:00:55 EDT 2013 | hegemon
With regards to first picture.(Large themal vias) I would attempt to measure the area of the ground pad, less the area of the "drain" holes or Thermal Vias. From that result I would reduce the aperture to account for about 50% coverage of that remai
Electronics Forum | Wed Jun 12 13:27:28 EDT 2013 | joeherz
Our customer wants to do an overmold operation (3rd party to us) on the non-populated side of a rigid flex assembly. Their inquiry below: "We are going to end up over molding plastic over the back of this rigid flex to form an enclosure but wanted
Electronics Forum | Mon Jul 29 08:45:37 EDT 2013 | gallionc
We've been running our ICOM 5000 off and on since it was new in 1996. There's not much help out there for this machine as Stoelting (who bought out Westek) no longer supports it. You might need to replace the filter, which Stoeling can provide, but
