Electronics Forum | Mon Nov 05 16:54:00 EST 2007 | bbarton
There are several things that can be done to increase throughput on you screen printer, including the panelization of your bords as Steve & Hussman has pointed out. However that's of limited use if you have plenty of stock that is not panelized. That
Electronics Forum | Thu Nov 15 08:25:08 EST 2007 | rgduval
I do think that the designer goofed, and used too large vias. I believe he only used on size via on the entire board, regardless of whether it was in a pad, or out on the board. I have seen vias in pad work, though. From a manufacturing standpoint
Electronics Forum | Tue Nov 06 14:39:52 EST 2007 | patrickbruneel
ERA to support industry on new reviews of all RoHS exemptions and addition of new substances Below the part from the article related to lead in solders. �The whole life cycles of substances should be considered and lead in solders provides a good e
Electronics Forum | Tue Nov 20 19:08:15 EST 2007 | Peter
Hello, I would like to ask for opinion on an epoxy application. We apply RTV to bond and secure 2 electronic devices on a PCB. But after noticing the RTV bond breaking off during vibration test, our customer has specs in a 5min 2-part epoxy (made
Electronics Forum | Fri Dec 07 12:01:14 EST 2007 | elg1
The 3000 hours is correct. It was a VERY fast ROI! Back to the discussions on the earlier threads, some of this information is correct. If you exceed the design limitations for keep out requirements and your board tolerances vary, you can have twe
Electronics Forum | Fri Dec 14 18:32:39 EST 2007 | kroberson
What machines have you worked with previously? Depending on the programming software used, CP6 can be relativly easy to program. CP6 has been a workhorse in the industry for a long time. One the process is set up, maintain the machines acording t
Electronics Forum | Mon Dec 17 11:55:08 EST 2007 | chef
I recently had the same problems, solder bridges on every thing I made, different customers boards, etc. I wave with no-clean flux. As I sorted out problems (pin holes, blow holes, splatter, etc.) I found a lot of variable factors. I changed flux,
Electronics Forum | Mon Dec 17 08:58:21 EST 2007 | Frank
You can spend a couple grand on a manual screen printer, or do what I did back in the day: place the board on the work bench and lay the stencil on the board. If you can hold it steady enough you can use a putty knife to apply your paste. For the s
Electronics Forum | Thu Dec 20 23:56:35 EST 2007 | isd_jwendell
I run a prototype/small-run shop, so I'll include some recommendations too: 1) Don't buy a machine for just what you are doing today. Once you get into this field you will find demand to do more. 2) Don't scrimp on the stencil & machine. You will spe
Electronics Forum | Mon Jan 14 17:15:24 EST 2008 | jmelson
$200 is iffy, even for a used, reconditioned unit. I got an aged Olympus for about that some years ago, but had to make my own stand. There is a Chinese-made stereo microscope (no zoom) that is absolutely worthless for inspection, because the "thro