Electronics Forum | Fri Sep 05 08:54:09 EDT 2014 | oxygensmd
My problems was solved. I needed to recalibrate the sprinkler. I used the service account and adjusted the settings in the sprinkler setup window. After a few test it work perfectly. Thanks for help guys!
Electronics Forum | Tue Aug 12 09:52:58 EDT 2014 | thiagofrego
Would like to know if some exists norm that refers the parameters for test of extraction (pull test) of components SMD using adhesive.
Electronics Forum | Wed Aug 20 13:03:57 EDT 2014 | vipin_nmt
Triple Lane NXT Modules cannot be used for Single Lane and had PCB limitation of 250 x 170 mm only. do we have any solution.
Electronics Forum | Thu Aug 21 09:01:35 EDT 2014 | jax
You should never try to print more than one board at a time if utilizing a fixture. You should have a single image fixture for the printer and an array fixture for the machines... where fiducials can be used to correct positional variations.
Electronics Forum | Tue Sep 23 16:17:35 EDT 2014 | aybars
I will be happy to buy one of them. We purchased a used 1800EXL just recently and it did not come with any manuals. I will appreciate any help you can provide. I can be contacted at (954) 424-4554. Best regards, Aybars Ocal
Electronics Forum | Mon Aug 25 20:14:35 EDT 2014 | nhel_0009
Yes sir we're using tray elevator..but i'm thinking with manual tray for another options.thank you
Electronics Forum | Mon Aug 25 10:44:35 EDT 2014 | sharanabasaiah
Hi, which is the best suitable used PNP for start up
Electronics Forum | Wed Aug 27 13:59:10 EDT 2014 | jimmyboz
Or else, as Dman may have been pointing to, duplicate the first fid sequence, and use it as the block skip mark, if found, then the next sequence is the fid it already found as a block skip mark....
Electronics Forum | Thu Aug 28 02:51:01 EDT 2014 | padawanlinuxero
When you say "selecting correct value of the small chip components during assembly", you are referring to caps and resistors? and that you want to know that the correct cap or resistor was place in the correct location? your assembly is surface moun
Electronics Forum | Mon Sep 08 11:38:52 EDT 2014 | spoiltforchoice
They key requirement before any fancy tools is careful storage, stock control, labeling and handling. If your parts are incorrect before they even get to production, you're screwed. As gregp suggests, to get consistently correct value and orientation