Electronics Forum | Fri Jan 18 14:06:06 EST 2013 | maurdane
I have some boards that go through the assembly process on our SMT Line mounted on SMT Fixtures. Currently, we are experiencing some quality issues (shifting, tombstones, etc) on some of these assemblies as a result of not being able to keep the PWBs
Electronics Forum | Mon Jan 21 08:44:00 EST 2013 | emeto
Hi, as far as I remember Juki machines have sendor to check if there is a feeder high. So you have several thingd to check here: 1. Check if there is a feeder high 2. check the sensor calibration. I think it is a beam from one side that goes streig
Electronics Forum | Mon Jan 21 08:49:43 EST 2013 | cnotebaert
Sorry to keep brining up such old topic! I’m looking for some help. I have a CP4-3 that I’m getting up and running. It was last interfaced with Flexa software, however I’m looking at connecting an F4G or MCS30 to it. Does anyone know if it was upgrad
Electronics Forum | Mon Jan 21 11:28:28 EST 2013 | dhopps
The machine will have to be reset-started to wipe the current proper and status out of the machine before you can communicate with an MCS. This can be dangerous if you do not have a current paper copy or disk back-up of your proper because you will
Electronics Forum | Wed Jan 30 17:23:07 EST 2013 | dyoungquist
In response to hegemon... This is not a recommended practice but..... We have added a few drops of water soluble flux to our water soluble solder paste when the paste is on the stencil. This was after the paste had "dried" out a bit. We have had
Electronics Forum | Thu Jan 24 09:09:13 EST 2013 | ercdave1
Thank you Sr.Tech. I have a little experience with smt machines. the machines were fuji xp series but they were brand new with warranty and service contract that i didnt have to worry about paying for. now i am on my own and trying. the informatio
Electronics Forum | Thu Jan 31 08:27:32 EST 2013 | phase1
Hello, We have just aquired an MV-2HTL AOI with the NG marker option. We are looking for someone familiar with these machines to provide training. I have programmed a board already using the manuals but am not confident as to what values and passing
Electronics Forum | Tue Feb 05 14:35:30 EST 2013 | rway
In order to test a reed switch on the Teradyne, you will need an electro-magnet mounted inside the fixture. It will need to be mounted directly under the reed. First perform the passive testing (TVSV or Cont), then the active test. Drive the coil
Electronics Forum | Fri Feb 08 18:35:20 EST 2013 | johnniek
We currently use Assembleon Gem series pick and place machines. We have no problems using them other than they are not intended to run 0201 or 01005 components. We are looking to buy another machine to add to our lines that would be capable of doing
Electronics Forum | Tue Feb 12 10:55:42 EST 2013 | marcelorotofrance
I didn't knew about this procedure because it doesn't appears in the manuals I have. These are not originals but incomplete photocopies (this is one of many problems of this machine) that I have compiled from other colleagues. I jus received just som