Electronics Forum | Wed Aug 19 07:06:06 EDT 2015 | namcom18
Hi I have a 1010, that I believe is not functioning correctly on startup. I have used MPS1030p, MPS1020p and mx200 machines before as a comparison. Usually with the above machines once the pc has turned on and serial communication is connected thro
Electronics Forum | Thu Aug 20 15:12:44 EDT 2015 | superlen
I don't know that you find anything off the shelf that fits all of your requirements, but it wouldn't be too hard to create a system that does *most* of what you want. You could at least have it read the code off the pcb & alarm if it doesn't match
Electronics Forum | Mon Sep 14 23:21:06 EDT 2015 | solderotter
Hi there. We’re Solder Otter, a team of recent engineering graduates from the University of Waterloo in Canada that is redesigning the soldering iron so soldering electronics can be safer and simpler. You may have seen the survey we posted back in 2
Electronics Forum | Mon Sep 28 09:31:43 EDT 2015 | proceng1
Proc > > My field service back ground included > Electrovert so I know reflow electrical quite > well. I've worked on Heller, Conceptronic and > Vitronics over the last few years and really > there isn't a huge difference if you can read a > sc
Electronics Forum | Sat Oct 03 21:36:33 EDT 2015 | cadco
Update 6 Oct 15: We have completely re-configured the oven PID boards such that everything is now visible on the oven by the s/w and all is now OK since the "Machine"card is now recognized. We have just one additional procedure to do and that is
Electronics Forum | Sat Oct 10 02:59:53 EDT 2015 | aemery
AVCOM, I have worked on a few of the Conceptronic ovens recently for one of my clients. They had a similar issue, all the heaters dropping out with a high temp circuit error which kicks out CON1 (Heater power). If you're saying what I think your sa
Electronics Forum | Fri Nov 06 07:46:33 EST 2015 | clampron
Good Morning RedChilli, I have worked with Mirtec for quite a few years. I have looked at some of the other machines mentioned but have no practical experience with them. I started with the Mirtec MV-2 (long ago)due to the success of this platform,
Electronics Forum | Fri Nov 20 03:47:22 EST 2015 | spoiltforchoice
When detected, a PCB with an FTDI FT232 IC will install drivers on the host PC and it will appear as a standard serial port. You can transfer data over it in the same way you would any other serial port,you can also inerface with it using FTDI's own
Electronics Forum | Wed Apr 06 08:54:35 EDT 2016 | spoiltforchoice
Essemtec like to keep some details to themselves to make you initiate contact but the Jet nozzle page states it can do 0.4mm dots. Last I checked a single Jet dispenser was about £15k GBP, the Scorpion machine itself is effectively the same platform
Electronics Forum | Mon Jan 25 15:51:02 EST 2016 | aemery
SP1 is a bi-metal spring loaded switch or the "air fault" switch on the main air manifold that detects the presence of an appreciate amount of air being supplied to the machine. Air pressure overcomes the adjustable spring and closes the contacts.
