Help!
Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything seemed to work fine, until monday. After I finished the job I was working on I loaded the next job and received a Qsoft.exe error, a page fault or something I don't remember anymore. I replaced the calibrat.cfg file with a backup we had stored elsewhere. Then proceeded to load all the feeders and Vibe bases into the machine. After teaching all the pockets and inserting my first board it placed about 300 components and then it quit running. The error it gave was (Head#1 Qalign Failure on D13[8]QA Error: Bad Alignment.. Side 2 Failure). I checked all the connections on the Qalign units and everything seemed to be fine, rebooted and ran another board. This time it only placed about 100 components and then it quit again, same error but on Head 2 and a different component. I have tried recalibrating both quad align units and Qqlign 1 gives me a message to check image FOV? (no clue how to do this) Qalign calibrates fine.
Ok i tried running at 70% speed (saw this mentioned in another thread) any idea why i cant run at 100% speed?
Any help would be greatly appreciated
reply »