Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 3697
Guys,
What DFM is standard for Minimum Edge Clearance on ...
- May 03, 2006
by
IPC or DFM? Most DFMs are controlled by the equipment restr...
- May 03, 2006
by
Most, if not all, DFX guidelines are Equipment dependant. Yo...
- May 03, 2006
by
JAX
SMEMA standards are 5mm edge clearance
...
- May 03, 2006
by
RDR
Chunks,
Have you been off on a Yogic enlightenment course...
- May 04, 2006
by
Rob
Sounds like you're mad because they installed a "Yogic Only"...
- May 04, 2006
by
We get away with edge clearance of 5 mm on the bottom side a...
- May 06, 2006
by
Mika
aj