Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 4572
All, Is it possible to wave solder the following componen... - Aug 22, 2006 by
Without having tried it, I'll be the first to say I don't kn... - Aug 22, 2006 by Steve Thomas
No, not by us mere mortals but where there WML there's hope.... - Aug 22, 2006 by Rob
Some university you went to, Rob. You can't even spell "old"... - Aug 22, 2006 by Steve Thomas
Cannot be done, no way to solder the heat pad underneath ce... - Aug 22, 2006 by RDR
Russ is right. The pad in the middle needs to be soldered a... - Aug 22, 2006 by
I did not think it was possible but I just thought I would a... - Aug 22, 2006 by
National says: [ ... - Aug 22, 2006 by davef
Nope, and, Be careful with the "grid" on your stencil for... - Aug 23, 2006 by Darby
we had problems with fillets and shifting aswell,but the rec... - Aug 24, 2006 by
Darby National published stencil recommendations for their ... - Aug 24, 2006 by davef
I too had to reduce by 50% because of floating (0.006"). Bu... - Aug 24, 2006 by
We reduce 50% on that pad and achieve excellent results as w... - Aug 24, 2006 by RDR
Dave, Cygnal was taken over by Silabs. I based my design on ... - Aug 24, 2006 by Darby
Russ, Do you use on print offset on the leads? I kepp ... - Aug 25, 2006 by
We'd do it the same way that you did, except apply no solder... - Aug 25, 2006 by davef
One big pad, one 50% app in the stencil. ... - Aug 25, 2006 by
We sire don't AJ, We use a single large aperture in center ... - Aug 25, 2006 by RDR
We use a single large pad on board and reduce stencil apertu... - Aug 25, 2006 by RDR
aj