Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 6810
All, We have ran a few revisions of a New Product which i... - Jan 09, 2007 by
Not unless it's a case of "the only difference is..." What ... - Jan 09, 2007 by Stephen
Dear AJ, Try removing shield ,test it, verify if it would... - Jan 09, 2007 by
Shields can carry a large thermal mass. If you ever tried r... - Jan 10, 2007 by Real Chunks
We ran 4 boards without shields and they work fine. ... - Jan 10, 2007 by
We also took the shields off one of the boards and retested ... - Jan 10, 2007 by
Your evaluation results confirms that Real Chunks is right... - Jan 12, 2007 by
All, I ran a failed board back thru reflow with shields r... - Jan 12, 2007 by
I think she might be more on track about the air flow. I wou... - Jan 12, 2007 by Stephen
Hi all, What length of time is recommended for the "soak ... - Jan 13, 2007 by
All, The component that seems to be effected most is a : ... - Jan 16, 2007 by aj
How close is the "fence" to the part in question? ... - Jan 16, 2007 by Steve Thomas
2-3mmm from edge of component ... - Jan 17, 2007 by
2-3mm would seem close enough to affect the air flow and I w... - Jan 17, 2007 by Steve Thomas
All, apologies for dragging this thread up again but afte... - Jan 18, 2007 by
Is the failure just out of tolerance or is it non functionin... - Jan 19, 2007 by lit51
aj