Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 7530
We keep seeing a problem with the plastic tool tip on an A12...
- Jul 17, 2007
by
Peter Allgood
Is your machine a TP9 2U ?
If you have a UFP or a MY seri...
- Jul 17, 2007
by
Sr. Tech
Thank you for the reply - and yes its a TP9-UFP! Problem d...
- Jul 18, 2007
by
Peter Allgood
I was asking if it was a TP9 2U......
If you have a UFP ...
- Jul 18, 2007
by
Sr. Tech
Sorry I misunderstood, its a UFP. And yes it does wobble as...
- Jul 18, 2007
by
Peter Allgood
Bad small X motor most likely.
Other possibilities:
Bad ...
- Jul 18, 2007
by
Sr. Tech
OK thanks - I wasnt aware that I HAD a small x motor! You m...
- Jul 18, 2007
by
Peter Allgood
send me an e-mail and I will give you the test procedure.
...
- Jul 18, 2007
by
Sr. Tech
You dont mention if it is ONLY occuring with the A12 or is i...
- Jul 19, 2007
by
Chris1963
Hi
Thanks for the input. Problem is only ever the A12 p...
- Jul 19, 2007
by
Peter Allgood
Chris,
Are you sure about the joystick trackball statement?...
- Jul 19, 2007
by
Sr. Tech
Peter,
GO TEST YOUR SMALL X-MOTOR IN THE SERVICE PROGRAM !!...
- Jul 19, 2007
by
Sr. Tech
Ok I can get into the service program - under Motors there i...
- Jul 19, 2007
by
Peter Allgood
You might want to check the Xwagon bearings. We had the same...
- Jul 19, 2007
by
jamyboy
Yes that sounds worth a look - thanks.
I am also wonderin...
- Jul 20, 2007
by
Peter Allgood
Sr. Tech, youre absolutely correct that the X-Wagon (pancake...
- Jul 20, 2007
by
Chris1963
If you still have trouble with this problem try calling MyDa...
- Jul 20, 2007
by
Chris1963
Well yesterday was uncharacteristically warm for a British s...
- Jul 20, 2007
by
Peter Allgood