Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 7291
I am getting the following error on our MY9 during hardware ...
- Feb 21, 2020
by
tomdegas
Have you performed the maintenance? It might need grease, or...
- Feb 21, 2020
by
SMTA-Alex
SMTA
Thanks for the quick response. I’ll try it tomorrow and let ...
- Feb 21, 2020
by
tomdegas
I cleaned and re-greased everything on the Hydra head and I ...
- Mar 03, 2020
by
tomdegas
So to sum up:
you have no mechanical blockage, you have new ...
- Mar 03, 2020
by
Evtimov
I swapped out the cable with no luck. The Hydra Z controller...
- Mar 03, 2020
by
tomdegas
I don't remember as it has been a while, but this is the boa...
- Mar 03, 2020
by
Evtimov
That error means your hydra z did not reach it's specified p...
- Mar 04, 2020
by
bruce
I appreciate the help. The Hydra travel is fine and goes do...
- Mar 04, 2020
by
tomdegas
The mot mi board is the first board but it is two boards tie...
- Mar 04, 2020
by
bruce
I swapped the mi boards with ones from a working My12 machin...
- Mar 05, 2020
by
tomdegas
Another thing you can check is where the bar comes down off ...
- Mar 06, 2020
by
bruce
The fact, that your Hydra head goes up and then starts movin...
- Mar 06, 2020
by
SMTA-Alex
SMTA
Have you try doing initialization from service menu? Exit TP...
- Apr 04, 2020
by
Tim
I have tried that Tim and I get the same error message. Ori...
- Apr 06, 2020
by
tomdegas
Try swapping XWB board that is on top of X-Wagon. Have you t...
- Apr 06, 2020
by
Tim