How to reduce the PCBA warpage issue after Reflow oven for 1mm PCB Thickness

Subscribe to Thread

How to reduce the PCBA warpage issue after Reflow oven for 1... - Sep 02, 2020 by SMThyd

1. Reflow carrier 2. Reduce panel quantity and size ... - Sep 02, 2020 by researchmfg

Just what was said plus 3. the number of solid tabs can be ... - Sep 02, 2020 by Evtimov

at first , you need to optimise your panel design ( lenght w... - Sep 12, 2020 by Djo

A reflow oven with Center rail support can help. If your vo... - Sep 14, 2020 by DWL

SMThyd

#85584

PCBA warpage issue | 2 September, 2020

How to reduce the PCBA warpage issue after Reflow oven for 1mm PCB Thickness

reply »

researchmfg

#85586

PCBA warpage issue | 2 September, 2020

1. Reflow carrier 2. Reduce panel quantity and size

reply »

Evtimov

#85587

PCBA warpage issue | 2 September, 2020

Just what was said plus 3. the number of solid tabs can be increased for stability.

reply »

Djo

#85633

PCBA warpage issue | 12 September, 2020

at first , you need to optimise your panel design ( lenght width & postage stamp ) , use an anti-buckling cable during first reflow , and you can put trays under your panel during first reflow..

reply »

DWL

#85634

PCBA warpage issue | 14 September, 2020

A reflow oven with Center rail support can help.

If your volumes are too low to justify spending $$ on a proper carrier, titanium stiffeners applied to the PCB before it goes into reflow is a cheap, albeit manual solution.

reply »