FUJI IP3 placing rotation error

Subscribe to Thread

Hello ! FUJI IP3 left head sometimes places component with ... - Jan 11, 2024 by madisreivik

Check the top of the placing head. There are 3 screws aroun... - Jan 11, 2024 by Travis H

Indeed I found some vacuum problems, one replaced small hose... - Jan 12, 2024 by madisreivik

contact Mike Forseen at SMT research he is very knowlegable ... - Jan 23, 2024 by triplettx3

madisreivik

#90447

FUJI IP3 placing rotation error | 11 January, 2024

Hello !

FUJI IP3 left head sometimes places component with rotation error. Vision processing SHOWS that component needs rotation Mechanical side is checked, looks fine. Also, changed servo, no effect.

It happens randomly, maybe 1 part from 30. It does not depend much of component or nozzle size, so nozzle slip is not an issue.

Looks like software sometimes "forgots" to adjust Q axis after vision processing.

Its super annoying headache. Please help !

reply »

Travis H

#90448

FUJI IP3 placing rotation error | 11 January, 2024

Check the top of the placing head. There are 3 screws around a piece that pops up when you push up on the nozzle. I had one once that was vibrating and causing the part to place slightly off angle. It is exposed to the vacuum used to pick the parts, they can get dirty and cause an odd vibration. Usually have to just clean it.

reply »

madisreivik

#90452

FUJI IP3 placing rotation error | 12 January, 2024

Indeed I found some vacuum problems, one replaced small hose was not fitted correctly. Lets see if that helps :)

Great thanks !

Also, Travis, do you have any information how to adjust the milk-plexiglass slitted covers on line scan cameras ?

reply »

triplettx3

#90485

FUJI IP3 placing rotation error | 23 January, 2024

contact Mike Forseen at SMT research he is very knowlegable on all the older Fuji machines, i have alot of spare parts if you ever run into a jam.