| | I have a recent design (1 component side only) that calls for 2 surface mounted antenna's (brass plated) to be mounted on a PCB. The problem arises when the PCB is 18x11.25 and has 15 to 20 PCB's in the pallet (IE weight, fixturing to hold the antenna's parallel to the PCB). The other issue is reflow oven clearance (we had planned on running these antenna's through the SMT line, its dimensions are 1.75" tall, 1.245" dia, .020" wall thickness and 1.75" tall x .460" dia, .020" wall thickness). �We have a Heller 1800W (nitrogen ready)with only aprox. 1.5" of total clearance. I need sugguestions from anyone who might be doing something similar, or know of equipment, or techniques. Thanks | | | Please clearify... | The oven Tunnel height. | The product height. | Are you running this on the mesh or the edge hold chain? | | I have 6 Heller 1700 series and the tunnel height (from the mesh) is over 2.25 inches. | Dean | | The fact that we have the CBS (center board support) is the main issue. We only have 1.5" (max) from the edge guides to the top of the heated tunnel. The CBS eliminated the mesh belt in the Heller design. A pallet design to recess the board is one approach, but I am concerned that since the panel has 15 boards within the array that position of components will be difficult to say the least. The shear fact that there are no supporting leads to hold up the two antenna's will require a hold down fixture, which means more of a height issue. I believe that a secondary operation is the only solution, even if it is for the short term.
reply »