Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
A quick question(s) to anyone who operates SMT lines with on... - May 06, 2003 by gregp
A typical machine will have around 100 feeder slots. Manufac... - May 06, 2003 by
You misunderstand...I am not a CEM rather I am representing ... - May 06, 2003 by gregp
Sorry, I did misunderstand. My opinion would be: Assuming n... - May 06, 2003 by
Thanks for the response k_h, A few follow up questions... ... - May 09, 2003 by gregp
72 different part numbers, 53 being 8mm, remainder being 12-... - May 09, 2003 by
"Point of use" could be your common high runner parts. Th... - May 09, 2003 by gregp
Thinking about it, if I was designing machines and based on ... - May 09, 2003 by
Each machine has two feeder tables, one is fixed, the other ... - May 09, 2003 by
KH This won't work if your planning on running these 2 ma... - May 09, 2003 by
I find 100 feeder slots of 16 mm width quite sufficient. If ... - May 10, 2003 by Stefan Witte
Hello Stefan, Thank you for your reply. I see now that man... - May 12, 2003 by gregp
1. Not quite. The width of 16 mm came most likely from the r... - May 12, 2003 by Stefan Witte
I currently am doing it. Keep in mind the parts are split up... - May 13, 2003 by
I know, it can be done and I participated in many acceptance... - May 13, 2003 by Stefan Witte