Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
What is the general feeling in the industry on the use of 15...
- May 29, 2003
by
Steve Schrader
I do not recommend using a HASL finish, you will have a very...
- May 29, 2003
by
swagner
We place a large amount of .4mm (what is that in microns?)QF...
- May 30, 2003
by
RDR
Conversion refresher:
1 inch = 25.4 mm
1 inch = 25,400 m...
- May 30, 2003
by
Jon Fox
Hi Steve,
Why are you so concerned about QFP(0.4) or BGA? I...
- Jun 02, 2003
by
Evtimov
yo Evt,
".., what's the difference?". Answer: Huuuge!! bet...
- Jun 02, 2003
by
PeteC
Orrrrrr, you could eliminate the printing, shorting, and spe...
- Jun 03, 2003
by
Hi Pete I agree with all that. But his question was "Are mos...
- Jun 04, 2003
by
Evtimov
Steve Schrader