Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Hi, I know this must have been asked a lot of times, howe... - Dec 02, 2003 by
$90K is a good budget. Check out Dek and MPM. www.dek.com ... - Dec 03, 2003 by
Hi, Each people will have diff idea. If you ask me... wit... - Dec 03, 2003 by vmach1
For half the money you can pick up a used Dek 265 GSX which ... - Dec 03, 2003 by
You can get a new DEK ELA fully automated stencil printer wi... - Dec 03, 2003 by
Hello As some one already said Dek and MPM printers are ver... - Dec 03, 2003 by valuems
....the printer may have less impact on your 0402 / 0201 qua... - Dec 03, 2003 by
I think Ekra is a good option, is very easy machine to use a... - Dec 04, 2003 by M S
Hi Grant, I'm ex Fuji Service Engineer, Fuji GP 6xx is th... - Dec 04, 2003 by
Dear Mr. Petty: I woould welcome the opportunity of discussi... - Dec 10, 2003 by
I agree with all the comments saying MPM and DEK are OK, but... - Dec 10, 2003 by
CHECK INTO WARRANTY AND SERVICE BEFORE MAKING THE DECISION O... - Dec 10, 2003 by mrmaint
HI, We have seen a couple of statements that we just have... - Dec 14, 2003 by valuems
I would say the DEK printer I have had the best reliability ... - Dec 15, 2003 by
Ahmen Brother! I had the unfortunate pleasure of supporting ... - Dec 15, 2003 by
Hi, Thanks for the feedback, and this has been helpful. S... - Dec 16, 2003 by
I could probably have sold you a 2 year old E5 for about $35... - Dec 18, 2003 by Steve Thomas
Hi Grant, I have experience with both MPM and DEK... - Dec 18, 2003 by alwil
I have had both DEK and MPM. I have had far better success w... - Dec 20, 2003 by SMT Eng 1001
Hi, Ok, and thanks for the advice, I am going to check in... - Dec 20, 2003 by
Hi, I am now looking at a DEK as an option, and might rai... - Dec 23, 2003 by
Grant, You cannot go wrong with a DEK. They are extremely ... - Dec 23, 2003 by SMT Eng 1001
Hi, Thanks for the advice, and what models are you runnin... - Dec 25, 2003 by
Grant, Sorry for the delay in a response, I just got back in... - Jan 06, 2004 by SMT Eng 1001
hi grant, why you choose not mpm is clear for me not good... - Jan 10, 2004 by
I'm looking for a shareware software that I could use for sp... - Feb 18, 2004 by
Hi, We settled on a high end DEK Horizon printer, and tha... - Feb 19, 2004 by
Grant, Congradulations on your choice, I think you'll be hap... - Feb 19, 2004 by SMT Eng 1001
Grant Petty