Sal: You and Wolfgang are spot on, but let's see if we can blow this out a bit.
Before proceding to rattle on ... � PC Card. A credit card-size computer peripheral that add memory, mass storage, and I/O capabilities to computers in a rugged, compact form factor. � PCMCIA (Personal Computer Memory Card International Association). A non-profit trade association and standards body that promotes PC Card technology, along with Miniature Card and SmartMedia cards by defining technical standards and educating the market.
In the past, cards were known as "PCMCIA Cards", but the industry now refers to products based on the technology as "PC Cards," "PC Card Hosts," and "PC Card Software," and refers to the association as PCMCIA.
Now, on with the rattling ...
Sounds like, during reflow one part, either the board or the QFP, becomes a maxed-out potato(e) chip and the other is a minnied-out potato(e) chip. Since this appears to be putting strain on the solder connections at the corners of the QFP, I�m not real excited about the potential impact on long term reliability of your product from the sounds of things.
I�m all farklempt. Discuss among yourselves (as Linda Richman used to say): � Be wary of using components with Alloy 42 leads on thin substrates (ie, PCMCIA, flex), because of the lack of compliance of the leads and different Tce. Some people believe Alloy 42 leads are a reliability problem regardless of the substrate. It�s easy to determine if leads are Alloy 42 (or Kovar), because they�re magnetic. (Copper leads are not magnetic, as you know.) An additional issue is poor solderability of Alloy 42, but this doesn�t seem to be an issue for you � knock on wood. � You didn�t mention carriers (pallets). We use carriers with all thin substrates. Many people, like the disk drive industry, don�t use carriers. OK, we�re wimps. But, we get plugged designs. Izit we get plugged designs and that makes us wimps �cause we�re forced to put-up that bull funky? ... Orzit we�re wimps, so they give us plugged designs? ... What ever. Although the SMTnet archives list carrier suppliers, the transition from fabricating FR-4 wave solder carriers to PC Card and flex carriers is not trivial. � Try panelizing the boards "side-by-side" in a 4-up panel. This improves machine throughput and reduces the scrap material. Additionally, the twisting of each board tends to cancel-out the twisting of the other. � Consider adding outside tabs along the length of the panel (~0.16" - 0.20"). Most pick/place equipment need at least 0.16" for conveyors to move the panel from one site to another. These should be routed off after assembly. Also, global fiducials can be placed on the tabs for the screen printer without taking up precious PCB real estate. This will improve panel to panel rigidity. � Leave at least 3 "break-away" tabs between each board to provide additional support and minimize panel warping. � Consider using the mesh-belt on the reflow oven, rather than the chain-rail system. This reduces panel drooping and warping during reflow. With the mesh-belt, a support carrier is unnecessary, assuming minimal board warping and similar Tce of components. � Think about slowing-down the drive on your reflow to provide more time for temperature change to affect all components equally.
Ta Dave F
reply »