Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 5991
I am putting together an internal oven calibration procedure... - Feb 10, 2006 by RFredericks
Russ, We use a unit called a Datapaq surveyor to monitor ou... - Feb 10, 2006 by Sr. Tech
We do the same as SR Tech but add in a check of the thermoco... - Feb 10, 2006 by jdengler
We do something quite simple that may or may not be adequate... - Feb 10, 2006 by RDR
Establish a profile board. It should be representative of w... - Feb 10, 2006 by
One factor everyone overlooks is that furnace and external T... - Feb 11, 2006 by
Hi, Does it really matter what temp the oven runs at as l... - Feb 13, 2006 by Grant
That's why I parallel ported the T/C's. Now I can use a cal... - Feb 13, 2006 by
Hi Grant, Most inspectors want your oven temps close to ... - Feb 13, 2006 by
I believe I understand what Ken is talking about. Most "cal... - Feb 13, 2006 by Stephen
Thanks everyone, I have found your postings very helpf... - Feb 13, 2006 by RFredericks
I have been through this before. At a med. device company th... - Feb 13, 2006 by Steve Thomas
Same way. Either plug into existing T/C or use a hand held ... - Feb 13, 2006 by
ECD's OvenRIDER is the only instrument I know that can measu... - Feb 13, 2006 by PeteC
Ah yes, environmental chamber. Jargon updated, thanks! ... - Feb 13, 2006 by RFredericks
You are correct. Regardless of what any auditor is asking w... - Feb 13, 2006 by
Samir, I didn't get the e-mail unless I thought it was spam... - Feb 20, 2006 by PeteC
I agree with Steve and would hate to have Ken audit me. "... - Feb 22, 2006 by