Reliable counting equipment for SMT components required

Subscribe to Thread

Could anyone recommend any companies who manufacture counte... - Jan 06, 2000 by

Damian, I have used the Schleuniger, Inc. CC-15 components... - Jan 06, 2000 by Christopher Lampron

I have used the PC-2500 from V-TEK and have encountered no ... - Jan 07, 2000 by Bill Copperthwaite

Somehow the link did not show up. They are at www.vtekusa.c... - Jan 07, 2000 by Bill Copperthwaite

Damian Oatway

#7943

Reliable counting equipment for SMT components required | 6 January, 2000

Could anyone recommend any companies who manufacture counters for reeled components. Anyone who has any info on the accuracy and reliability of these systems and if there are any alternatives to the usual systems? Cheers.

reply »

Christopher Lampron

#7944

Re: Reliable counting equipment for SMT components required | 6 January, 2000

Damian,

I have used the Schleuniger, Inc. CC-15 components counter. This is a hand crank operated instruments that counts the holes in the carrier tape. It is simple to operate and set up. We have found the accuracy to be upwards of 98% providing that the operator does not rush the job. This is the only Tape and Reel components counter I have ever used so I have nothing to guage it against.

Hope this Helps

Chris

reply »

Bill Copperthwaite

#7945

Re: Reliable counting equipment for SMT components required | 7 January, 2000

I have used the PC-2500 from V-TEK and have encountered no problems. It has a motorised reel handling system and can handle various tape pitches and reel sizes.It has an accuracy in excess of 99%.Check out their website below.

Billc

reply »

Bill Copperthwaite

#7946

Re: Reliable counting equipment for SMT components required | 7 January, 2000

Somehow the link did not show up. They are at www.vtekusa.com

Regards,

Bill

reply »