Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Quad QSP-2 Z-hight wrong

Views: 1065

#82709

Quad QSP-2 Z-hight wrong | 6 June, 2019

Hallo...Quad have problem with z, going to wrong. Parst to high and can not measuring. No errors. Have some body this problem and solutions? Thank you.

reply »

#82710

Quad QSP-2 Z-hight wrong | 6 June, 2019

If the part is 10mm or less as long as you are scanning it near the top...it should work. The other possible problem is dirt on the quadalign lens. Clean off the lens and watch it when it homes....both heads should home the same way. If the head jumps up very quickly at the end of homing you need to clean the lens.

good luck, Bob

reply »

See Your 2024 IPC Certification Training Schedule for Eptac

Sell Your Used SMT & Test Equipment