| looking for help with fine-pitch printing for what would be the best settings for printing speed, squeegee pressure, seperation speed. | thanks for you time Brian: As Justin says - the issues are many. However, a good start would be to run at 0.75 inches per second print speed with normal ( 1 to 1.5 lbs per squeegee blade inch) pressure. Separation of stencil from board is incredibly important. You may want to build in a delay before separating table from stencil and separation should not be real quick but rather quite gentle to let the solder stick to the pads on the board. What pitch are you printing? This makes a definite impact on how much to undercut your apertures on the stencil to compensate for fine pitch. Also, the thickness of the stencil comes into play here also. Come to think of it, give me a call at 215.741.1822 or email me with the details of what make and model your printer is, what kind of paste you are using, how big is the board, and what is the tightest center to center pitch. end of line
reply »