Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Hello, We recently installed a new/used UPK 650 fitted wi... - Jan 23, 2003 by hoss67
While not familiar with the flux, I'd increase the conveyor ... - Jan 23, 2003 by davef
How are these connectors and dips oriented? If the leads are... - Jan 24, 2003 by RDR
I sent you a couple of charts to assist with your troublesho... - Jan 24, 2003 by PeteC
I am not familiar with your flux but with no-cleans (which I... - Jan 24, 2003 by
Hi, Distance Engineering is always difficult. I am gue... - Jan 24, 2003 by
RMA needs to be dry prior to the wave to work. If coverage ... - Jan 24, 2003 by TriGuy
DDave, I do not have the benefit of having the old machin... - Jan 24, 2003 by hoss67
Correction: The Ultrapak (UPK) 600 and Electra models allow ... - Jan 24, 2003 by PeteC
Hi Again Distance is tough, besides far less exciting.. ... - Jan 24, 2003 by
I agree with most of the other suggestions here, but 90 C fo... - Jan 28, 2003 by MikeF
I've seen this problem on more than one wave,What i've done ... - Jan 28, 2003 by sajulius
Mike, I've tried the high side of the flux preheat spec w... - Jan 28, 2003 by hoss67
Hi Wow, I can't imagine this set up. No wonder some of u... - Jan 31, 2003 by
Dave, I do have the mechanical drawings but no electronic... - Jan 31, 2003 by hoss67
I would go for the laminar flow as opposed to N2. The conto... - Jan 31, 2003 by RDR
Hoss, if you have trouble with finding the parts you need th... - Jan 31, 2003 by RDR
Russ, Roger that. Thanks. ... - Jan 31, 2003 by hoss67