Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
A quick question(s) to anyone who operates SMT lines with on...
- May 06, 2003
by
gregp
A typical machine will have around 100 feeder slots. Manufac...
- May 06, 2003
by
You misunderstand...I am not a CEM rather I am representing ...
- May 06, 2003
by
gregp
Sorry, I did misunderstand. My opinion would be:
Assuming n...
- May 06, 2003
by
Thanks for the response k_h,
A few follow up questions...
...
- May 09, 2003
by
gregp
72 different part numbers, 53 being 8mm, remainder being 12-...
- May 09, 2003
by
"Point of use" could be your common high runner parts. Th...
- May 09, 2003
by
gregp
Thinking about it, if I was designing machines and based on ...
- May 09, 2003
by
Each machine has two feeder tables, one is fixed, the other ...
- May 09, 2003
by
KH
This won't work if your planning on running these 2 ma...
- May 09, 2003
by
I find 100 feeder slots of 16 mm width quite sufficient. If ...
- May 10, 2003
by
Stefan Witte
Hello Stefan,
Thank you for your reply. I see now that man...
- May 12, 2003
by
gregp
1. Not quite. The width of 16 mm came most likely from the r...
- May 12, 2003
by
Stefan Witte
I currently am doing it. Keep in mind the parts are split up...
- May 13, 2003
by
I know, it can be done and I participated in many acceptance...
- May 13, 2003
by
Stefan Witte