Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Hi,
I know this must have been asked a lot of times, howe...
- Dec 02, 2003
by
$90K is a good budget.
Check out Dek and MPM.
www.dek.com
...
- Dec 03, 2003
by
Hi,
Each people will have diff idea. If you ask me... wit...
- Dec 03, 2003
by
vmach1
For half the money you can pick up a used Dek 265 GSX which ...
- Dec 03, 2003
by
You can get a new DEK ELA fully automated stencil printer wi...
- Dec 03, 2003
by
Hello
As some one already said Dek and MPM printers are ver...
- Dec 03, 2003
by
valuems
....the printer may have less impact on your 0402 / 0201 qua...
- Dec 03, 2003
by
I think Ekra is a good option, is very easy machine to use a...
- Dec 04, 2003
by
M S
Hi Grant,
I'm ex Fuji Service Engineer, Fuji GP 6xx is th...
- Dec 04, 2003
by
Dear Mr. Petty: I woould welcome the opportunity of discussi...
- Dec 10, 2003
by
I agree with all the comments saying MPM and DEK are OK, but...
- Dec 10, 2003
by
CHECK INTO WARRANTY AND SERVICE BEFORE MAKING THE DECISION O...
- Dec 10, 2003
by
mrmaint
HI,
We have seen a couple of statements that we just have...
- Dec 14, 2003
by
valuems
I would say the DEK printer I have had the best reliability ...
- Dec 15, 2003
by
Ahmen Brother! I had the unfortunate pleasure of supporting ...
- Dec 15, 2003
by
Hi,
Thanks for the feedback, and this has been helpful. S...
- Dec 16, 2003
by
I could probably have sold you a 2 year old E5 for about $35...
- Dec 18, 2003
by
Steve Thomas
Hi Grant,
I have experience with both MPM and DEK...
- Dec 18, 2003
by
alwil
I have had both DEK and MPM. I have had far better success w...
- Dec 20, 2003
by
SMT Eng 1001
Hi,
Ok, and thanks for the advice, I am going to check in...
- Dec 20, 2003
by
Hi,
I am now looking at a DEK as an option, and might rai...
- Dec 23, 2003
by
Grant,
You cannot go wrong with a DEK. They are extremely ...
- Dec 23, 2003
by
SMT Eng 1001
Hi,
Thanks for the advice, and what models are you runnin...
- Dec 25, 2003
by
Grant, Sorry for the delay in a response, I just got back in...
- Jan 06, 2004
by
SMT Eng 1001
hi grant,
why you choose not mpm is clear for me not good...
- Jan 10, 2004
by
I'm looking for a shareware software that I could use for sp...
- Feb 18, 2004
by
Hi,
We settled on a high end DEK Horizon printer, and tha...
- Feb 19, 2004
by
Grant, Congradulations on your choice, I think you'll be hap...
- Feb 19, 2004
by
SMT Eng 1001
Grant Petty