Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 8360
Hello all, we are having issues with some specific package ... - Nov 07, 2007 by jdumont
I have not seen hold size as an issue when switching Sn/Pb t... - Nov 08, 2007 by PeteC
Hole size may not have been an issue for you because your ho... - Nov 08, 2007 by jdumont
60% ratio would be great start. that is what we typically sh... - Nov 08, 2007 by RDR
Josh: Your 0.009" [0.228 mm] clearance should be fine. The m... - Nov 08, 2007 by davef
Did the PTH barrel ends in massive copper clad ? If yes thi... - Nov 08, 2007 by JOSEPH
We design and assemble PCB's and use a min of .015 thou over... - Nov 09, 2007 by cadpac
Thanks for all the great suggestions guys. We do not have to... - Nov 09, 2007 by jdumont
Try raising the part off the board a little. I bet this wil... - Nov 09, 2007 by Hussman
Are you thinking for the soon to be displaced air to be able... - Nov 09, 2007 by jdumont
Josh: 2222 will meet your requirements. 2221 is a companion ... - Nov 10, 2007 by davef