Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 4679
I am trying to optimize my reflow profile. i have a 5 zone o... - Jul 25, 2008 by brettc
What paste are using? You should referance the manufactures ... - Jul 25, 2008 by Chip_Flip
I am not very concerned about production time, but it is alw... - Jul 26, 2008 by brettc
Ideal situation is get a technical rep from the solder paste... - Jul 28, 2008 by blnorman
Do you have a Slim-Kic? You can run a profile and then do p... - Jul 28, 2008 by Real Chunks
thanks, looks like an interesting product. any idea of the c... - Jul 28, 2008 by brettc
Take a look at this. Remember, these are only guidlines and... - Jul 28, 2008 by garyr
my oven has a built in profiler, it works fairly well, but i... - Jul 28, 2008 by brettc
Oh, well if you can profile, model your profile to the profi... - Jul 29, 2008 by Real Chunks
Some profiles can be difficult to get exactly, so I was wond... - Jul 29, 2008 by brettc
Slight variations should have little impact on your product ... - Jul 29, 2008 by Real Chunks
You can keep only the 5th zone as the reflow zone. And lower... - Aug 01, 2008 by Leo
Is there a limit to the time that most components can stay a... - Aug 02, 2008 by brettc
If you have concerns, you can look at the datasheet for each... - Aug 04, 2008 by garyr
brettc