Dear Users!
I have a Topaz pick&place machine, but the conveyor motor is not working.
1st test - production: Start production in "operation" menu: if I put the PCB the entrace of machine, the assembly head-bank picks up the first 8 components (precede pick is ON) and waits for transfer. After 5-8 seconds the machine throws "PCB Transfer Error" If I switched the PCB transfer mode into manual and adjusted the PCB into the correct mounting position, the machine could be working well, but this mode is very annoying.
2nd test - mechanic: With my hand, I can rotate the gear output of the motor, and conveyor follows the rotation. It needs equal force if machine is switched off or conveyor motor is switched on/off in menu. I didn't hear any sound while motor was switched on.
3rd test - manual switch on: In submenu "conveyor units" I switched on the conveyor motor manually (while covers are closed and machine is not in emergency-stop state. The motor is not working. In menu "output monitor" I switched on the conveyor motor manually, checked the option "slow" and "reverse" mode. The motor is not working. Near the trafo, I've found the control relay of conveyor motor, and I can hear a thick if I switch on/off the motor.
4th test - motor replacement: I have a same type motor(Panasonic M8RX25G4L) and replaced. The motor is not working.
Please help me.
reply »