Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Minimum tension to be maintained in SMT stencil

Views: 1088

#84240

Minimum tension to be maintained in SMT stencil - Any Standards | 21 January, 2020

Dear Experts,

Need your suggestion on the minimum tension to be maintained in the SMT stencil.

Presently we are maintaining the 30 - 50 N/cm2 at the 4 corners of the stencil.

And not considering the center of the stencil into consideration..

Is there any standard to be maintained. Please help me to get some standards on the same.

Regards, Ameen

reply »

#84244

Minimum tension to be maintained in SMT stencil - Any Standards | 21 January, 2020

What does supplier say?

reply »


SMTA-Davandran

#84251

Minimum tension to be maintained in SMT stencil - Any Standards | 22 January, 2020

Same practice is maintain at my organisation but include center during each set up. This practice is to ensure that stencil is in good during production since no standard for stencil life span control.

This message was posted via the Electronics Forum @ SMTASMTA

reply »

#84517

Minimum tension to be maintained in SMT stencil - Any Standards | 23 February, 2020

Read 35-55 @ 5 position, 4 corner and 1 center.

reply »

#84596

Minimum tension to be maintained in SMT stencil - Any Standards | 3 March, 2020

Dear All,

thanks a lot .

Supplier recommend same 35 - 50 n/cm.

But our customer is asking for any standard available in the industry to follow same.

Please share any standard . If come across.

Regards, Ameen

reply »


SMTA-Davandran

#84604

Minimum tension to be maintained in SMT stencil - Any Standards | 4 March, 2020

I got question on is there any variance for thickness of stencil with respect to stencil tension. Is ther any guideline for it.

This message was posted via the Electronics Forum @ SMTASMTA

reply »

#84613

Minimum tension to be maintained in SMT stencil - Any Standards | 5 March, 2020

The tension depends on the thickness of the stencil. Exp: stencil of 100µm => tension must be higher than 33N

Attachments:

reply »

On-board Dispensing of Dots & Lines

Conformal Coating Machine under 40000