Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 7340
I am getting the following error on our MY9 during hardware ... - Feb 21, 2020 by tomdegas
Have you performed the maintenance? It might need grease, or... - Feb 21, 2020 by SMTA-Alex SMTA
Thanks for the quick response. I’ll try it tomorrow and let ... - Feb 21, 2020 by tomdegas
I cleaned and re-greased everything on the Hydra head and I ... - Mar 03, 2020 by tomdegas
So to sum up: you have no mechanical blockage, you have new ... - Mar 03, 2020 by Evtimov
I swapped out the cable with no luck. The Hydra Z controller... - Mar 03, 2020 by tomdegas
I don't remember as it has been a while, but this is the boa... - Mar 03, 2020 by Evtimov
That error means your hydra z did not reach it's specified p... - Mar 04, 2020 by bruce
I appreciate the help. The Hydra travel is fine and goes do... - Mar 04, 2020 by tomdegas
The mot mi board is the first board but it is two boards tie... - Mar 04, 2020 by bruce
I swapped the mi boards with ones from a working My12 machin... - Mar 05, 2020 by tomdegas
Another thing you can check is where the bar comes down off ... - Mar 06, 2020 by bruce
The fact, that your Hydra head goes up and then starts movin... - Mar 06, 2020 by SMTA-Alex SMTA
Have you try doing initialization from service menu? Exit TP... - Apr 04, 2020 by Tim
I have tried that Tim and I get the same error message. Ori... - Apr 06, 2020 by tomdegas
Try swapping XWB board that is on top of X-Wagon. Have you t... - Apr 06, 2020 by Tim