Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


MPM SPM

Views: 489


MM

#85754

MPM SPM | 8 October, 2020

Does anyone have Page 6 and 7 of the MPM SPM manual? I am currently having issues with low air pressure that pushes the table in. I get good air that pushes the table to the entrance, but I do not get good air pressure that pushes the table in. I have tried swapping L2, but that did not affect it at all. I checked the hose, and that is fine. Any suggestions?

Thanks

reply »


DWL

#85755

MPM SPM | 8 October, 2020

Its been a while, but as I recall, there are two air valves under the table. one controls the exit speed, and one controls the entrance. You just need to fiddle with the valve until it travels at a decent speed.

reply »


MM

#85758

MPM SPM | 9 October, 2020

The problem is that I am not getting the air to the cylinder , so adjusting that wont do anything. I get air but it is not very much.

reply »

#85759

MPM SPM | 9 October, 2020

The docs are a bit weird, looks like they're setup as an interactive document, but they seem to work. Hopefully they have what you're looking for.

https://drive.google.com/drive/folders/11fXHLCSanZuqJYdH5uOUNVz4aZazWSEh?usp=sharing

reply »


MM

#85762

MPM SPM | 9 October, 2020

These were close. But our Machine is the SPM not SPM-AV.

reply »

Online IPC Training & Certification

Non-heated dispensing system