Wierd thing happened today with the HSP4791. All the programs and component definitions were wiped out (luckily they are all backed up on the terminal). And since the air compressor was shut down today to change the oil in the compressor, the 4791 has been stopping (the X,Y table that is) and the error is that it can not continue until the index angle is adjusted. Now, another thing is, the Pattern Error Correction camera appears to be out of calibration. The camera goes to the centroid of the comp, however it places the part +0.040 in the X (the Y is good). I am thinking that maybe doing a nozzle offset teach and head-center offset teach would correct this, but I wanted to ask someone who knows more about this than myself. What the major issue is that somehow all of the programs and components were deleted. If this is the case then most likely all of the parameters for this machine were deleted too. I know that there are 2 hard drives on this machine, what I don't know is what data is stored where. Also, the input and output conveyors on the machine aren't working all of the sudden. Does anyone have any suggestions.
reply »