Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Qualifying products in process?

Charlie

#3032

Qualifying products in process? | 13 September, 2000

I'm looking for practical proceedures to do the following: How to qualify epoxy in our process. One supplier vs. another. How to qualify wave solder and flux in our process. One supplier vs. another. Any and all advice is welcome.

reply »

#3033

Re: Qualifying products in process? | 13 September, 2000

Good question * Rich lathrop at Heraeus wrote a good paper on quantifying the printability of adhesives. You can probably find it on their site. * J-STD-001 is the baseliine for qualifying processes.

Good luck

reply »

Equipment Auction - Eagle Comtronics: Low-Use Electronic Assembly & Machining Facility 2019 Europlacer iineo + Placement Machine  Test & Inspection: Agilent | Tektronix | Mantis Machine Shop: Haas VF3 | Haas SL-20 | Mult. Lathes

Conductive Adhesive & Non-Conductive Adhesive Dispensing