50KV Portable Electrospinning high voltage power supply

50KV Portable Electrospinning high voltage power supply Description:

Product Name DEL
Power（W） 1.5W-75W
Output Voltage(KV) ,0.5,0.8,1,2,3,5,8,10,15,20,30,40,50,

 
Wisman’s DEL Series of regulated X-ray power supplies
offer output voltages to  50kV   High voltage and filament
current can be linearly ramped up. The DEL incorporates
local and remote programming, monitoring, safety interlock,ARC
short-circuit and overload protection.

TYPICAL APPLICATIONS
Electrophoresis X-ray Inspection Detector Arrays
Capacitor Charging
OPTIONS
NSS    No Slow Start
SS(X)    Non-Standard Slow Start
LL(X)    Extra Length Output Cable
AC      Filament
CPC    Constant Power
SPECIFICATIONS
Input:
85-265Vac, 47-63Hz
Output:
11models from 1kV,2.5KV,3K,5K,8KV,10KV,15KV,20KV,30KV,40KV to 50kV. Positive or negative polarity outputs.
Voltage Control:
Local: Internal multi-turn potentiometer to set voltage from 0 to full output voltage.
Remote: 0 to +10Vdc proportional from 0 to full output voltage. Accuracy: ±1%. ZIN: 10Mohm.
Emission Control:
Local: Internal potentiometer to set beam current between 0 and full output.
Remote: 0 to +10Vdc proportional from 0 to full output current.
Accuracy : ±1%. ZIN: 10Mohm.
Voltage Regulation:
Load: 0.01% of output voltage no load to full load. Line: ±0.01% for ±10% change in input voltage.
Current Regulation:
Load: 0.01% of output current from 0 to rated voltage. Line: 0.01% of rated current over specified input range.
Ripple:
0.1% p-p of output voltage.
Temperature Range:
Operating:  0°C   to 40 °C
Storage:   -40°C  to 80°C
Temperature Coefficient:
0.01% per °C, voltage or current regulated.
Stability:
0.02% per 8 hours after 1/2 hour warm-up.
Voltage and Current Monitors:
0 to +10Vdc proportional from 0 to rated output.
Dimensions:
0kV to 50kV:
H140mm x W120mm x D240mm.
Connectors:
HV Output Connector: Delrin type connector, recessed.
Cable assembly with mating connector 39.4in (1m).
I/O Connectors: 15 pin mini D-type Phoenix connector for
power, filament and monitor connections.
Remote Programming:
(P/O 15 pin “D” analog control interface) Permits remote
adjustment of the output voltage and current via an external
potentiometer and the internal +10V reference. By adjusting
the potentiometer from minimum to maximum, the desired
output may be selected.
Remote Monitor:
Test points are made available at J1 for monitoring voltage
and current outputs. The output polarity is positive from
0 to 10V equal to 0 to 100% of the output.