GE Fanuc Multilin Digital UR 6DH 6D I/o Module 16 Inputs

GE Fanuc Multilin Digital UR 6DH 6D I/o Module 16 Inputs Description:

#Contact#
Unik You
unik@cambia.cn
+86 18030205725

Before you can use the Ethernet Interface with the Series 90-30 PLC, you must configure the Interface using the PLC programming software. The PLC programming software allows you to specify the modules and I/O that will reside in your Series 90-30 PLC rack(s). The Hand Held Programmer can not be used to configure the Ethernet Interface. For the Ethernet Interface specifically, the configuration software allows you to: „ Define the Status address of the Ethernet Interface. „ Assign the IP address for the Ethernet Interface, and optionally the subnet mask and the gateway address. „ Configure the serial ports (optional).

After configuring the Interface as explained in Procedure 2, follow the procedure below to verify that the Ethernet Interface is operating correctly. 1. Turn power OFF to the PLC for 3–5 seconds, then turn the power back ON. This will initiate a series of diagnostic tests. The OK LED will blink indicating the progress of power-up. 2. The LEDs will have the following pattern upon successful power-up. At this time the Ethernet Interface is fully operational and on-line.