Electronics Forum | Tue May 26 10:23:53 EDT 2009 | mun4o
hi, i am proccess eng solder wave process.I have problem with a PCB.There have ceramic SMD capacitor, SMD thermistor and SMD inductor 1uH.After reflow all is OK, but after SW these components are broken???The pin is separated from the body???the que
Electronics Forum | Wed Aug 13 19:57:05 EDT 2014 | suroy
After wash cycle, some of the inductors are open (broken wire). Resistance across the two ends should be below 4 ohms (normal) however on broken wire shows above 200 ohms. I am wondering if anyone else has seen this problem. We are using High-Reliabi
Challenges of Lead-Free Low Silver Content End Termination Pastes for Inductor Applications Challenges of Lead-Free Low Silver Content End Termination Pastes for Inductor Applications The silver end termination plays an important role
Imagineering, Inc. | https://www.pcbnet.com/blog/circuit-board-repair/
doesn’t have to be like this. You can give your broken PCB new life if you know what to look for. From physical damage to power failure, there are a few reasons a PCB can stop working