Electronics Forum | Fri Dec 03 18:01:56 EST 1999 | M Cox
Usually the alignment problem comes from pad design. The ground pad (largest) is too small. If that is the case (and even if it isn't) try placing a dot of SMT adhesive before placement (it will cure before reflow and hold the part in place). Goo
Electronics Forum | Thu Dec 02 23:43:23 EST 1999 | Kantesh Doss
We have a serious misalignment problem of D-Pak components (Specifically Motorola's part number MJD-3055/MJD-2955)following reflow soldering process. We are using Alpha Metals UP78 solder paste. Our reflow oven is Nitrogen inerted and our oxygen leve