Electronics Forum | Tue Aug 14 13:54:57 EDT 2018 | etmpalletguy
Vlad, Reduce your aperture opening in the stencil, this will give the stencil a good seal around the specific area of concern. In a wave solder environment, solder balling top or bottom surfaces in a wave pallet is caused by excessive flux burning o
Electronics Forum | Tue May 26 11:13:49 EDT 2009 | xinxi
Is the components on the top or on the bottom of the pcb? Have you checked whether the temperature on pcb are too high when it pass through SW that it exceeds the limit that the components can take? Do check with the component manufacture for the te
GPD Global | https://www.gpd-global.com/co_website/fluiddispense-prod-dsseries.php
Dispense System for Large PCB, Pallets Home Products Fluid Dispensing Equipment High Precision Dispenser -MAX Series Large Format Board Dispensing -DS Series Table Top Dispensing Equipment Loader
| http://etasmt.com/cc?ID=te_news_bulletin,25762&url=_print
. PCB board during transport It won't fall off. 7. The high temperature can reach 235 °C -245 °C and can withstand a temperature of 350 °C. 8
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830