Electronics Forum | Tue Aug 14 13:54:57 EDT 2018 | etmpalletguy
Vlad, Reduce your aperture opening in the stencil, this will give the stencil a good seal around the specific area of concern. In a wave solder environment, solder balling top or bottom surfaces in a wave pallet is caused by excessive flux burning o
Electronics Forum | Tue May 26 11:13:49 EDT 2009 | xinxi
Is the components on the top or on the bottom of the pcb? Have you checked whether the temperature on pcb are too high when it pass through SW that it exceeds the limit that the components can take? Do check with the component manufacture for the te
Baja Bid | https://bajabid.com/wp-content/uploads/2023/06/XT-V-130-flyer-EN.pdf
. With the XT V 130, you can get the inside view of printed circuit boards, in a smooth, non-destructive process. The Nikon Metrology XT V130 X-ray inspection system is a high-precision, flexible solution that facilitates defect analysis in loaded PCB boards. Designed for 100% BGA and
Surface Mount Technology Association (SMTA) | https://www.smta.org/europe/
. The day started off with introductions and the information on the facility and most importantly lunch and refreshments. Workshop Delegates at Henkel Listening to Bob