Electronics Forum | Tue Jul 02 15:13:13 EDT 2019 | daniel_marquette
On our QSP-2, the Y axis belts start to vibrate during the process so we need to open the doors to stop this because of the humming sound. What can creates this knowing that all the movements and placement are spot on?
Electronics Forum | Mon Dec 22 04:55:41 EST 2014 | bobpan
Swap the amps but first manually check by hand to make sure the z-axis is free to move up and down. Sometimes a part can get stuck in the gears. Good Luck
| https://www.eptac.com/faqs/ask-helena-leo/ask/reliability-of-reworked-lead-free-assemblies
. The intent is based upon IPC-4101 and whether or not leaded solder or lead-free solder is being used. You state “…Our present process: 2 heat excursions, thru reflow, 2 thru wave, one thru rework
Baja Bid | https://bajabid.com/wp-content/uploads/2023/06/XT-V-130-flyer-EN.pdf
• Small footprint and low weight for easy installation 2 Image intensifier (Z-axis) X-ray source Moving the sample closer to the x-ray sources increase the magnification of the resulting image X-ray insight into the inside Tracing hidden defects and internal imperfections With the
.jpg)