New Equipment | Solder Materials
FCT Assembly Fluxes are designed to be used with both SN100c and SAC305 alloys. By combining our latest flux tecnologies with SN100c, FCT Assembly has an advantage over all other suppliers in paste, wire and flux. FCT Assembly Flux Comparisons:
New Equipment | Wave Soldering
Vitronics Soltec’s Delta platform has evolved over generations of equipment, with thousands of machines operating worldwide. The Delta 5 represents our latest wave soldering solution, featuring easy setup and operation and is the most reliable, depen
Electronics Forum | Fri Jul 13 12:32:14 EDT 2007 | rgduval
We've experienced this issue with SN100. A couple of things we've tried, all with varying levels of success: 1. Longer pre-heats. We use SN100 in a solder pot, and pre-heat the boards on our wave machine. This did have a positive effect, but I ne
Electronics Forum | Thu May 22 14:44:10 EDT 2008 | samir
Does your top-side preheat NEED to be that high, and so high that you are exceeding the flux manufacturers' spec? If so, what is the reason? Top-side wetting? Are you measuring this temperature at the substrate or solder joint?
Used SMT Equipment | Soldering - Wave
Vitronics Wave Soldering Machine [Completely Refurbished] Model: Delta 5 Vintage: 2013 Lead Free or Leaded Capabilities - Bare Pot 18" Max Conveyor Width Software Version: Delta 5 V4.12.0 Double Wave (Main Wave & Chip Wave) Motorized
Used SMT Equipment | Soldering - Selective
Vintage 2019 The perfect plug-and-produce selective soldering system for entry-level automated soldering. holding device for workpiece carrier / workplace of 508 x 508 mm [20" x 20"], without downholders 3-axes system with spindle axes and AC servomo
Industry News | 2003-07-02 08:54:26.0
A novel unreinforced, thermally conductive, pressure sensitive adhesive tape delivers very high bond strength to low-energy surfaces.
Industry News | 2010-04-11 02:21:50.0
GREELEY, CO — FCT Assembly announces that it has been awarded an NPI Award in the category of Flux for its NC160 lead-free flux. The award was presented to the company during a Tuesday, April 6, 2010 ceremony that took place in the Mandalay Bay Resort & Convention Center in Las Vegas during APEX 2010.
Electrovert's DwellFlex 4.0 is the first solder nozzle designed specifically with Industry 4.0 automation in mind. The patent pending design enables the length of the wave to be adjusted on-the-fly as variable board types are run through the wave.
DescriptionThe Electrovert® Electra™ is an advanced, meticulously engineered wave soldering system designed for high-mass and high-volume manufacturers. Although intended for maximum throughput requirements, the Electra also offers maximum process fl
.gif)
.gif)