New Equipment | Board Handling - Conveyors
Model No: KSUN 250 Automatic Sucking Loader PCB loading time: Approx 6seconds Magazine change-over time: Approx 30 seconds Power supply: 100-230V AC (customized ), single phase, MAX 300V/A Air pressure: 4-6 bar, MAX 30L/minute Transport height:
New Equipment | Board Handling - Conveyors
Model No: KSUN 460 Automatic Sucking Loader PCB loading time: Approx 6seconds Magazine change-over time: Approx 30 seconds Power supply: 100-230V AC (customized ), single phase, MAX 300V/A Air pressure: 4-6 bar, MAX 30L/minute Transport height:
New Equipment | Board Handling - Conveyors
product instruction ※PLC control system, Working is stably and reliably ※Easy to operate touch screen control interface ※the pneumatic clamps of top and bottom three point provided for the magazine alignment ※Electric pushing board design ca
The Triangle Electronics Group is an Independent Distributor of IC's, Semiconductors, and Electronic Components Specializing in Hard to Find, Allocated, or Obsolete IC's. Major Manufacturer's in stock include: NSC/FSC, TI, MOT, INTEL, AMD, ALTERA, A
The Cogiscan Product Flow Controller ensures traceability data integrity and error-proof line set-up. It controls the SMEMA connection and ensures that production doesn��t proceed to the next step of the process unless the barcode label on the PCB ha
New Equipment | Board Handling - Conveyors
The 90 degree Turn Conveyor is designed for changing the conveying direction of flow of a PCB production line. It's controlled with air cylinder; rotates smoothly and accurately. PLC Control System FUJI button or touch screen control, easy o
New Equipment | Board Handling - Conveyors
The PCB Conveyor is used in the PCB assembly line when frequent visual inspection of PCB's is required. It can be used as an Inspection conveyor or a Linking conveyor. PLC Control System FUJI button for easy operation Four pitch selectio
New Equipment | Board Handling - Conveyors
The PCB Unloader is designed for unloading of PCB's, an arriving PCB is taken up by the attached conveyor and then pushed into the magazine by a specially designed pusher. The magazine indexes to the next postion and is ready for the following unload
New Equipment | Board Handling - Conveyors
Connect with SMT and Al production lines. Safety design ensures not to break any PCB when it is pushed and thus reduce defect rate. Agility operation. With high accuracy, automatic counting, fault alarm functions, it is required for a full range of a
New Equipment | Board Handling - Conveyors
Our standard unloaders are the most cost-effective PCB unloaders of the different series. They are used to unload the PCB’s out of the production line by pushing them into standard magazine racks, basically designated for assemblers who use only one
winsouce.jpg)
