Electronics Forum | Mon Sep 06 08:05:51 EDT 1999 | stefano bolleri
| We are using some Fuji machines and have trouble picking parts up from damaged or mis-adjusted feeders. When I was working with Panasonic machines I was able to buy a feeder alignment jig from them to align the pick spot in the feeder, but Fuji doe
Electronics Forum | Mon Sep 06 14:01:08 EDT 1999 | KEVIN SIMPSON
| | We are using some Fuji machines and have trouble picking parts up from damaged or mis-adjusted feeders. When I was working with Panasonic machines I was able to buy a feeder alignment jig from them to align the pick spot in the feeder, but Fuji d
Electronics Forum | Tue Nov 03 16:28:21 EST 1998 | Dave F
| Well my process is I'm running my belt speed at 3.50fpm and about 215 to 225 degrees top side. I got my main wave down to a little less than half the board thickness. I'm not using a hot air knife cause we thought it might create more of a problem
Electronics Forum | Mon Jul 27 17:38:55 EDT 1998 | Steve Gregory
Hi Stoney, Justin is giving you some good advice, unfortunately these kinda' problems sometimes call for the ol' D.O.E...otherwise, you could be chasing your tail for a while until you figure out exactly what's causing your problems. Has the ep
Electronics Forum | Tue Jul 28 09:22:16 EDT 1998 | Justin Medernach
| Hi Stoney, | Justin is giving you some good advice, unfortunately these kinda' problems sometimes call for the ol' D.O.E...otherwise, you could be chasing your tail for a while until you figure out exactly what's causing your problems. | Has
Electronics Forum | Mon May 07 11:09:49 EDT 2007 | davef
4 Fluxer Operation 4.1 Set-Up and Check-Out the Fluxer 4.1.1 Spray Fluxer Set-Up and Check-Out 4.1.1.1 Pass a sample unsoldered board through the machine. 4.1.1.2 Remove the board just after passing through the fluxer and the air knife. 4.1.1.3
Electronics Forum | Tue Dec 14 22:17:33 EST 1999 | Dave F
Armin: How ya doin� bud? CK gives good advice, but I'd like to take a bit of a different angle. Q1. For 0.7 mm (0.027in) diameter hole for vias, what�s the minimum annular ring for this hole diameter? Depends on what you�re trying to do. For in
Electronics Forum | Tue Sep 07 14:24:20 EDT 1999 | johng
| | We are using some Fuji machines and have trouble picking parts up from damaged or mis-adjusted feeders. When I was working with Panasonic machines I was able to buy a feeder alignment jig from them to align the pick spot in the feeder, but Fuji d
Electronics Forum | Wed Sep 08 16:56:06 EDT 1999 | Md Cox
| | | We are using some Fuji machines and have trouble picking parts up from damaged or mis-adjusted feeders. When I was working with Panasonic machines I was able to buy a feeder alignment jig from them to align the pick spot in the feeder, but Fuji
Electronics Forum | Tue Aug 04 11:10:22 EDT 1998 | Chrys
| Hi Stoney, | Justin is giving you some good advice, unfortunately these kinda' problems sometimes call for the ol' D.O.E...otherwise, you could be chasing your tail for a while until you figure out exactly what's causing your problems. | Has
