Electronics Forum | Fri Dec 08 19:10:29 EST 2000 | Dave F
Try these guys, they do more environmental ovens than your momma!!! LR Environmental 12902 S.Spring St Los Angeles CA 90061 800.574.2748 213.770.0634 fax0105 sales@lre.com www.lre.com John Kline
Electronics Forum | Tue Feb 17 05:23:00 EST 2015 | shahrat
I am planning to Bye Mirtek MV-7 omni AOI machine. Can anyone tell me what are the possible breakdown of this machine and how much stable machine is this. In terms of long run, False call. Can I check 0105 package by this machine? and also BGA IC ?
Electronics Forum | Thu Feb 06 17:16:41 EST 2003 | gregp
I do not know about the cost issues but as I recall the tolerances are tighter on bulk components and this usually means higher cost. I cannot find my bulk feeding summit information but these links give you some idea what was discussed. I don't kn
Electronics Forum | Wed Feb 06 15:51:26 EST 2008 | jax
We have place CSP devices with 0.105mm standoff hights without any issue. The ability to Water Wash all depends on the specifications of your wash... Spray pressure and qty of jets Dwell time, pre-wash/wash/rinse Available detergents or saponifiers
Electronics Forum | Thu Feb 12 22:21:08 EST 2015 | shahrat
So what problems you are facing with Mirtec? Can u check coplanarity, less solder, polarity, dry solder,Pads not properly got the heat for 1005 package. Can u also check 0105 components that is surrounded by some tall components? what about false cal
Electronics Forum | Mon Feb 16 12:33:58 EST 2015 | ianatvadatech
Hey Syed, I've been running the MV-9 for just over a year. We shopped around very extensively (two APEX shows) before switching from yestech to mirtec and we bought two of the best systems they had to cover the four lines we run. Two systems are fa
Electronics Forum | Thu May 07 11:39:29 EDT 1998 | Dave F
| Is there a machine for bending S shaped bends in leads | of through-hole components, to keep them off the surface of the board. Ryan: Some lead forming equipment can form leads to stand-off the board. Some lead forming equipment suppliers are: Au
Electronics Forum | Wed Dec 02 09:28:24 EST 1998 | Dave F
| Hi, | I'm looking for a small batch convection oven that will replace the dryer section of a batch ultrasonic cleaning machine to dry off excessive water from washed PCB's, | any suggestions for particular suppliers, will be appreciated. | Jack |
Electronics Forum | Tue Apr 17 19:58:49 EDT 2007 | davef
Equipment||Lead Forming||Olamef||||619.792.7328 fax 1966 ?? Equipment||Lead Forming||RotoForm||||423.266.0067 fax 0105 Equipment||Lead Forming||Streckfuss||||214.790.1614 fax 986.1148 rep Foundation Technologies Equipment||Lead Forming||TED/Heller|||
Electronics Forum | Thu May 10 21:45:41 EDT 2007 | davef
Comments are: * Mass lead trimming equipment suppliers are: ** Q Corp; 301 River St, Derby, KS 67037; 800-835-1099 316-788-3746 F316-788-7428 qcorporation.com qcorp@qcorporation.com ** Microscan [LT1821 Lead Trimmer]; ?? ** Roto-Form; PO Box 118; Si
