Electronics Forum | Mon Nov 12 12:00:30 EST 2001 | caldon
A real small soldering iron, a real steady hand, a qualified solderer. Soldering skill set is key. Iwould sugest a Micro scope. Sonora Mfg (I am sure there are others)has an infinate scope that you can solder under. aside from that....skill set.
Electronics Forum | Mon May 13 12:23:56 EDT 2002 | andyy
I agree with gregp on this one. I'm not going to discuss AOI as my company manufactures AOI systems, but I will comment on the CMM question as I use/have used these to qualify calibration targets and to characterize our systems. We actually have a
Electronics Forum | Tue Jan 01 22:50:53 EST 2008 | fastek
To get beyond the 36,000 cph threshhold the turret manufacturers had to focus on ways to get the boards in and out of the machine faster. This also included loading more boards inside the worknest. The end result in Fuji's case (CP-643), was a table
Electronics Forum | Tue Jul 10 11:25:36 EDT 2007 | jax
Multiple Factors that account for Scrap: During Set-Up: A percentage will not work. When setting up feeders you will normally use a certain length of populated pockets. The amount of parts this affects depends on 1.type of feeder 2.type of part
1 |