Electronics Forum | Mon Jul 10 11:38:15 EDT 2006 | Rob
Hi Dougs, I think I'm going to have to admit to some insider knowledge here. It kind of gave it away when you mentioned there were only catalogue pages instead of specs. http://www.anglia.com/product_search/part_tracker/index.asp I think you may
Electronics Forum | Wed Feb 29 06:33:49 EST 2012 | amitsindwani
Please define the defect in following conditions & link to IPC 610 clause/sub-clause no.: 1. 0603 component placed on 0805 PCB pad 2. 0805 component placed on 0603 PCB pad 3. 1206 component placed on 1210 PCB pad and 4. 1210 component placed on 1206
Electronics Forum | Fri Dec 17 01:21:54 EST 1999 | Victor Salazar
Weare using a Home plate design on 1210 or larger, 20% reduction on pkgs from 1206 to 1210, 10% reduction on 1206 or smaller, 0 reduction on all leaded components(sot-23, IC's) with a 6 mil stencil. For fine pitch we are using 4mil stencils. We h
Electronics Forum | Thu Jul 25 18:41:52 EDT 2019 | myke03o
Hi I have solved the issue. The component cracking are the big 1210, 0603 and 0402 capacitors. After studying and testing in many type of solder. The best to use is SnPb and the components are the key - there are component which will tend to expand
Electronics Forum | Thu Jun 29 02:16:07 EDT 2006 | AR
We are experiencing some difficulties with reflow soldering a 1210-sized MOV with silver/palladium finish. The PCB finish is SAC. When inspecting the board after reflow it seems that nearly all solder is gone both from the pads and the component term
Electronics Forum | Tue Jan 29 08:21:50 EST 2019 | electronics101
Hi All, Can someone please help, I have a number of tall surface mount components that according to IPC 610 (8.2.2.3) are a fail due to the end termination not wetting at least 0.5mm + solder height. The components are very well soldered but the sol
Electronics Forum | Mon Dec 17 07:34:07 EST 2001 | Adam
Dear Colleagues Does anyone know or care to share any information as to typical torque values ( N/cm ) for components that have been placed using screen printing surface mount adhesive, using a plastic stencil ? Are there any industry set shear test
Electronics Forum | Sun Dec 03 10:05:22 EST 2000 | Steven J
Greetings to all. We are currently experiencing cracking of the ceramic capacitors, on both primary and secondary sides of the PWB. The components range in size from 1206, 1210, to 1815s. The cracks do not appear to alter the electrical properties
Electronics Forum | Fri Sep 27 10:01:25 EDT 2002 | stefwitt
chips up to 1411 ( I have not seen a 1411 component yet, but 1210 is a good number ) in 8 mm, IC up to SO8 in 12 mm, IC up to SOL 20 fit in 16mm tape. This is just a basic rule. You may also find SO 20 in 24 mm tape. More important is the reel width,
Electronics Forum | Fri May 04 12:19:53 EDT 2012 | gnus
I'm guessing you're running small batches of boards on the MyDatas. We had the same issue with management when they decided to save on parts (not realizing it cost them more in time and more frustration for us). We had Agilis feeders so that helped.
.gif)
winsouce.jpg)