Electronics Forum | Wed Oct 29 20:20:00 EST 2003 | PALAKORN
I'm one incharge of PCBA manufacturing. And our company under discussion about IPC manual order. But I'm not clear to selection. Do you know in PCBA manufacturing normally which IPC number need. Thank you,
Electronics Forum | Thu Oct 30 09:09:30 EST 2003 | alandra516
Contact Process Sciencies at 512 259-7070 and talk to Steven Schoppe. He can help you with that problem
Electronics Forum | Fri Nov 07 16:00:45 EST 2003 | Don A
It would depend on how many boards and parts you need to build. I would prefer an etch cut as it leaves the the part intact and you get the strength of the solder joint. It also reduces the handling of the BGA and associated damage from that
Electronics Forum | Thu Oct 30 09:20:07 EST 2003 | Chebby
Please anyone help. Who knows any reliable company where I can order development of electronic devices. I need to make a project (electronic device) from scratch, but not too expansive. Anyone knows?
Electronics Forum | Thu Oct 30 09:44:06 EST 2003 | Bob
Perhaps I can help. I run a small development company. We do product design, prototyping and small production runs of our own designs.
Electronics Forum | Fri Oct 31 09:04:25 EST 2003 | Bob
Web site is epi-usa.net I suggest you take a look and call Monday if you are still interested.
Electronics Forum | Fri Oct 31 11:37:35 EST 2003 | caldon
Hi John- Try http://www.Aimsolder.com There website has some articles regarding this. Also, try http://www.smtinfocus.com one of the best compiled resources I have come across. Cal
Electronics Forum | Tue Nov 04 10:21:40 EST 2003 | blnorman
One of the requirements for our components and PCBs is fluid compatibility. They are tested by a 30 second immersion in the applicable solvent/cleaner/fluid, then they are tested for functionality and degradation.
Electronics Forum | Tue Nov 11 09:29:12 EST 2003 | ehess
Bill, have you found the problem yet? We have been experiencing the same problem on our H-500C, and have found some clogging in the drain from build up caused by the de-foamer we use. Once cleared, the problem went away.
Electronics Forum | Thu Nov 06 19:14:59 EST 2003 | Grant Petty
Hi, Thanks and I would be interested to check it out. Can you pass me your email address, as I could not get it. Is there web based info on this? Regards, Grant Petty Blackmagic Design
