Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Tue Apr 21 02:28:54 EDT 2015 | dinhhuunam
Juki GL-1.... Any thoughts? I'm New to the > industry and I'm trying to buy a new screen > printer. I have two in mind, DEK and Juki. Hi Sir, I'll advise you the SJ INNOTECH Vision Screen printer Best Solution & Service for You Model HP-520S Hi
Electronics Forum | Tue Sep 29 01:51:37 EDT 1998 | Earl Moon
| I'm going to purchase a screen printer. | I've looked at the SMTech/Sigma 500 (also called Quad AVX500). | Has anyone any comments to this machine or production experience? | Anything would be appreciated. | I'ld like to hear any other type of ma
Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Thu Dec 16 06:06:52 EST 1999 | Stefan
Check the print gap and check the clamp edges, sometimes the clamps is damaged causing a distance between the PCB and the screen. Good luck
Electronics Forum | Mon Apr 24 09:43:47 EDT 2006 | printerman
What you describe is the X snuggers fitted into the workholder which do need either a flat board or good vacuum to work. There are several solutions. One solution you can try yourself is to use Vacuum cups, ( bellows type) designed into the workholde
Electronics Forum | Wed Jun 29 10:26:58 EDT 2011 | remullis
I've been using 29x29 framed screens for years. I have a company that has come up with a adapter that would mount in my screen printer and utilize just the foils of screens. It basically fits and is clamped into the adapter. I am struggling with floo
Electronics Forum | Thu Jun 30 13:00:14 EDT 2011 | scottp
I've been using a DEK Vectorguard frame for a couple months now and like it a lot. It uses air to clamp/unclamp the foil and both DEK Vectorguard and Alpha Metals Tetrabond foils fit the frame. Just about any decent stencil supplier sells Vectorgua
Electronics Forum | Wed Jun 29 14:27:07 EDT 2011 | wrongway
Hello all I have used a couple of types one of them only clamped on two sides and you used a wrench and screwed the bolt down till it was tight ( what is tight) and there was no fram at all around the stencil so people got cut. the second one we us
Electronics Forum | Tue May 29 17:24:28 EDT 2001 | hussman
OK, I have a new product being tossed over "the wall" that has a flex circuit layered into a standard FR board and protrudes out of it. The flex circuit is 0.022" thick and is the 3rd layer of 6 layers. The total board thickness of the FR board is
winsouce.jpg)
