Electronics Forum | Fri Jun 03 12:08:06 EDT 2016 | tnisbet
If the damaged / scratched area you're referring to is where to rollers ride, we have a repair kit that would save you some money. tom@goppm.com
Electronics Forum | Thu Dec 29 07:26:37 EST 2011 | janz
Hi, If this is sworf from pcb let say after routing of panel and sworf is attach to pcb cleaning with ultrasonics does not help unfortunatly. one of new cleaning technic which is worth to investigate is "snow jet". this is used during deburring and
Electronics Forum | Wed May 08 10:05:42 EDT 2002 | Claude_Couture
Maybe the problem is not the cutter, but the arm that advance the tape in the adjacent feeder gets actuated at the same time as the active feeder. line-up a feeder in pickup position visually, then turn the crank until the roller or feeder advance me
Electronics Forum | Thu Jul 21 21:36:46 EDT 2022 | ttheis
We are parting out a GSM2 machine and plan to keep most of the parts for spares but if there is some bracket, bearing, roller, switch, etc. that someone needs let me know asap and we'll see if we have it.
Electronics Forum | Tue Mar 05 11:07:17 EST 2019 | sumote
Looking to purchase a DIP lead forming tool. The tool that has the 2 rollers that let you place the DIP part on the rail and run it between 2 rollers (ball-bearing?). I found a place that once sold them. They were called an RS Pro IC Insertion Tool
Electronics Forum | Wed Feb 27 04:23:13 EST 2008 | fujillews
Hi It is best to fit the VGA camera for 0201 parts make sure your software is high enough..above v1.33 although you can place without but no so good. 0.4mm tapered nozzles are best. 0201 feeder the locator base in increased by aprox 0.3mm and the ind
Electronics Forum | Fri Feb 13 09:25:35 EST 2004 | jcdupree
Hi Patrick, I can easily troubleshoot ML, EL and SL 20 systems by phone or e-mail, but the MPC-29 is a bit more complex. The problem that you are describing was failry common, and there were a number of potential causes. First is to check if the dr
Electronics Forum | Wed Dec 07 17:56:36 EST 2011 | conjugate
I am actually a final year student in Brunel University,London. I`m just started with my major project and the main objective of this project is to perform feasibility study on automation in dust removal. My project title is Automatic PCB Surface Cle
Electronics Forum | Tue Jan 24 18:21:22 EST 2006 | fredc
I have some old Fuji windmills here and I checked the usefull travel. It is approxiamately 1.5mm, the nozzles are suposed to have .3mm "preload" wich will take away from the usable overtravel. The windmill I checked is a reject that from when we rebu
Electronics Forum | Tue Jul 13 14:36:55 EDT 1999 | JohnW
| I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick. |